BLOG

——

14

2024

-

06

The correct way to replace the oil seal of the micro-tiller

Author:


Replacing the oil seal of the microtiller requires the preparation of some tools.

1. Prepare the tools
Replacing the oil seal of the microtiller requires the preparation of some tools, including a wrench, hammer, scraper, cleaning cloth, lubricating oil, etc.
2. Disassemble the oil seal
First of all, you need to remove the spindle of the micro-tiller, and then use a wrench and hammer to remove the oil seal from the spindle, and special attention needs to be paid when disassembling it, so as not to damage other parts on the spindle.
3. Clean the oil seal seat
Clean the removed oil seal seat of old sealant and dust, which can be cleaned with a scraper and cleaning cloth. Special care should be taken to avoid scratching the oil seal seat when cleaning.
4. Install a new oil seal
Apply a layer of lubricating oil to the oil seal seat, and then slowly push the new oil seal into the oil seal seat by hand, and gradually pat it tightly with a rubber hammer until the oil seal is flush with the seat splicing.
5. Test the sealing effect of the oil seal
After installing the new oil seal, it is also necessary to test its sealing effect. The spindle of the micro-tiller can be fixed, a small amount of lubricating oil can be poured onto the oil seal, and it can be observed whether there is oil leakage around the oil seal.
In short, it is not difficult to replace the oil seal of the micro-tiller, and you only need to pay attention to the method and details, and you can solve the problem of oil leakage of the oil seal of the micro-tiller.

Special model of microwalk-behind tractor gearbox

Overview of the special reducer for micro-tillage

2024-05-11

Maintenance of agricultural machinery

During the operation of the locomotive.

2024-05-11